RPI Series Rack and Pinion
PRODUCT FEATURES & BENEFITS
Country of Origin: Assembled & Tested in USA, Built from globally sourced components.
Number of Sizes: 15
Valve Mounting: ISO 5211 (i.e. F05, F07)
Accessories Mounting: Namur
Unique DLS Design: The double limit stop (DLS) adjustment, located outside of the pressurized body, are easy to adjust while in service. Secondly, this design uses the entire piston face and not the pinion to stop the valve. This displacement of energy over the largest surface in the actuator prevents premature failure to the pinion by preventing all side loading.
Spring Design: Patented encapsulated spring design is pre-compressed for safety. End caps in double acting and spring return are the same dimensions, very simple to work with in the field with no special tools needed. This design saves the end user unnecessary weight, space, and cost.
Standard Bearing Material: Delrin which prevents water absorption, unlike seals made of Nylon
Bodies: Actuator bodies are made of extruded aluminum, providing a low friction smooth bores
Corrosion Protection: All bodies are anodized, polyester powder epoxy painted, stainless steel pinions available along with nickel impregnation
Serial Number: Every single actuator leaves the Paladon plant with a serial number that can be tracked. These serial numbers can be found on the actuator label and stamped into the actuator body.
Certifications: ISO 9001:2008, SIL3, GOST
40-150 PSI, one of the only rack and pinion actuators designed for low air pressures
DA 43,923 in/lbs.
SR-Ending 16,055 in/lbs.
Standard: -4 to +194°F
Hi-Temp: -15 to +320°F
Low-Temp: -40 to +194°F